Products > Computer to Plate >

Computer to Plate Metal Product Specification - ECRM Mako 2 Specs

Plate Sizes
Maximum: 22.0" x 26.4" (560 mm x 670 mm)
Minimum: 8.9" x 9.9" (228 mm x 252 mm)
For plate sizes between 22.0" x 22.0" (560 mm x 560 mm) and 22.0" x 26.4" (560
mm x 670 mm), an edge register pin bar is required.

Media Types
Violet-sensitive metal plates, sensitivity up to 10 µJ/cm2.
Yellow-safelight environment required for plate handling.

Recording Source
Violet laser diode (405 nm), available for photopolymer or silver halide plates

Resolutions
Seven resolutions from 1200 dpi to 3556 dpi (472 dpcm to 1400 dpcm)

Maximum Line Screen
200 lpi (78.7 lpcm)

Plate Throughput - Landscape
1270 dpi: 46.5 seconds
2540 dpi: 2 minutes 5 seconds
Production speeds based on a 15.7" x 20.08" (400 mm x 510 mm) plate.
System performance tests conducted in landscape orientation at 1270 dpi, 133 lpi and 2540 dpi, 200 lpi. Performance is dependent and may vary according to media type and processing conditions.

Plate Throughput - Portrait
1270 dpi: 59.3 seconds
2540 dpi: 2 minutes 39 seconds
Production speeds based on a 15.7" x 20.08" (400 mm x 510 mm) plate.
System performance tests conducted in portrait orientation at 1270 dpi, 133 lpi and 2540 dpi, 200 lpi. Performance is dependent and may vary according to media type and processing conditions.

Repeatability
0.001" (0.025mm) typical over six consecutive separations on plate. May vary according to media type and processing conditions.

Processing
Manual: After imaging is complete, the plate is moved to the processor by hand.
Online: The plate transport automatically moves the plate into the processor.

Environmental
Power: 100 -240 Volts; 3 Amps; 250 Watt maximum; 50/60Hz, single phase
Heat Dissipation: 850 BTU/hour
Weight: 280 lbs (127 kg)

Operating conditions
62°F to 86°F (17°C to 30°C); relative humidity 45-65%, non-condensing.
Relative humidity outside of this range may affect performance.